DIY Jhumka Making Tricks: Instead of throwing away old syrup bottle caps, make beautiful DIY earrings from them. Learn the easy way to make royal earrings from stones, pearls and kundan, which you can also try at home.
Whatever be the outfit, the look is not complete without wearing jhumkas. If you are also fond of wearing heavy earrings, then instead of spending time and money in going to the market again and again, why not prepare them at home. The special thing is that you will not have to buy anything to make these and you can make beautiful and royal looking DIY Jhumkas with just the lid of a syrup bottle. Let us know about this art-craft step by step.
What materials will be required to make jhumkas?
- To make syrup container plastic lid base
- b7000 Jaya Strong Adhesive Jewelry Glue
- To Decorate, Stone, Chain, Pearl Beads, Kundan Stone
- Small piece of plastic sheet,OHP sheet
- scissors, eyepin
- earring studs and stoppers
- pliers
Steps to make Jhumka
1) First of all, clean and dry the bottle caps. Now apply jewelery glue all around it. Immediately after this, place the stone from below the chain lid till the top. Make sure it covers the entire cap. Now put a sapphire stone chain in it and then wrap the pearl chain. Same thing has to be done with stone and pearl string also.
Read this also- Nail art with green bangles in Sawan, these 5 designs are the most beautiful
2) In the second step, stick a string of beads on the border of the lid to give a beautiful finish. At the same time, apply a little glue on the inside and apply golden or matching pearl-glitter. It will look attractive and beautiful.
Read this also- Don’t throw away Kulhar tea after drinking it, make a cute cactus planter like this
3) To prepare the top stud, apply jewelry glue to a small sheet of plastic. Stick a drop shaped kundan or stone in the middle of the sheet. Then make a beautiful border around the stone by stringing pearls. After drying, cut the edges of the sheet with scissors.
4) Now take an eyepin and pass it through a small hole in the top center of the earring. Put a small pearl on the lower end of the pin and make a loop with the help of pliers, so that it does not come out. Now connect the pin with the stud and stick the earring post at the back.
Your beautiful DIY jhumka is ready, which will not only look heavy and graceful but will also be light in weight. It can be worn on silk, Banarasi sarees, Anarkali suits, full length suits, Indo western without any hassle.
Source- Instagram-